Step by Step Duo X 2 Installation diagrams

Duo-X 2 Installation Diagrams for v1.6

Duo X 2 Mod Chip

When you have disassembled your Xbox you can start to install the chip:

First solder the male pin header in to the holes of your Xbox main circuit board (the top 4 holes are not used).

You insert the pin header in the top of the main board and solder it in from the bottom of the main board (you can use "Blue-Tack" to hold the pin header in place while soldering).

Pin Header Install v1.6

Now solder link wires to the points marked below (this is what's called a LPC Rebuild).
Next solder a wire from point "D0" on the chip to point "D0" on the bottom of the main circuit board (you can feed the wire through one of the holes next to where you soldered the pin header).

LPC Rebuild v1.6

Below is a diagram of a LPC Rebuild fully completed.

LPC Rebuild Completed

Next solder a wire from point "BT" on the chip to point "BT" located behind the eject button (shown below).

BT points for v1.6

Now you have finished the soldering, connect the male pin header you soldered earlier to the main board to the female pin header on the chip like the diagram below:

Please Note: In the picture below the D0 point is connected to the top of the main board but you will of connected it earlier to the bottom of the main board.

Mod Chip Installed

Make sure you are using bank1 on the chip for versions 1.6

Reassemble your xbox and follow operating instructions below:

Operation instructions

Turn the mod on: Turn on the xbox by the pressing power button - Mod chip is ON

Turn the mod off: Turn on the xbox by pressing the eject button - Mod chip is OFF (needed for xbox live)