Step by Step Aladdin Installation diagrams

Aladdin Installation Diagrams for v1.6

Aladdin XT

When you have disassembled your Xbox you can start to install the chip:

First solder the male pin header in to the holes of your Xbox main circuit board (the top 4 holes are not used).

You insert the pin header in the top of the main board and solder it in from the bottom of the main board (you can use "Blue-Tack" to hold the pin header in place while soldering).

Pin Header Install v1.6

Now solder link wires on the bottom of the main board to the points marked below (this is what's called a LPC Rebuild).
Next solder a wire from point "D0" on the chip to point "D0" on the bottom of the main circuit board (you can feed the wire through one of the holes next to where you soldered the pin header).

LPC Rebuild v1.6

Below is a diagram of a LPC Rebuild fully completed.

LPC Rebuild Completed

Next solder a wire from point "BT" on the chip to point "BT" on the main circuit board and do the same for point "L1" (point are located close to the controller ports on the main board).

Aladdin BT L1 points for v1.6

Now you have finished the soldering, connect the male pin header you soldered earlier to the main board to the female pin header on the chip like the diagram below:

Please Note: the diagram below is taken from the Duo chip but should be positioned in the same way when installed.

Mod Chip Installed

Reassemble your xbox and follow operating instructions below:

Operation instructions

Turn the mod on: Hold power button until front LED flashes red, then stays orange - Mod chip ON (flash protected)

Turn the mod off: Briefly press power button to turn on Xbox, power button stays green - Mod chip OFF

If you need to flash the mod: Hold power button for 5 seconds - Mod ON and Flashable (this is only needed for upgrading your mod chip).